Impregnating agent Note:

Note: do not understand the chemical characteristics of the product are in danger of causing impregnant curing

Issue 1 :

Save the environment this product may cause polymerization of high temperature curing

Solution: put immerse the glue in a plastic storage tanks shall be equipped with a temperature control in the refrigerator 5-20between, such as Winter Park, the reboot must check that the refrigerator is normal.

Unopened cans of impregnant (reinforcing agent) must be placed in 28℃ storage.

Unopened cans of impregnant (without stabilizer) storage at room temperature is valid for one year.

Issue 2 :

Air is the stabilizer of this product, such as a long time out, plastic storage tanks at the bottom of the infiltration agents not exposed to air for a long time a negative solution is stable.

Workaround: deactivate during the day to immerse in the impregnation tank and plastic tank conversion back and forth between three times, so enabling the impregnating agent has access to air at the bottom. If every day you do not need to do so. Such as retro-fitting air brake pipe at the bottom plastic storage tanks, in the period of suspension or continuous little valve a little clean air after work better. (Air must pass through the oil-water separator, to avoid bringing large amounts of water into the liquid. )

Suzhou immerse the filter of mechanical equipment co invention stir cooled one to immerse the bottle does not need to carry out such complex work, you only need to power on the line

Question 3:

Copper-impregnated with this piece of iron, copper scrap iron in impregnating agent, active copper ion iron ion is the infiltration of curing agent catalyst at high temperature reach air and glue at the bottom under adverse conditions, such as a copper ion iron ion exist accelerating glue curing of accident.

Solution: this product mainly for aluminum alloys, magnesium alloys, stainless steel and other non-active metallic and non-metallic, for more products and correct operation of the factory three packs of commitment to impregnant. But for three packs of copper iron factory does not, if a user at your own responsibility to copper iron pieces, in addition to strictly comply with the relevant operational requirements, you must immerse the cans and plastic storage tank installation of a cloth bag filter (factory), filter bags for 400 , a day before the adhesive liquid filter, The workpiece into the copper scrap iron chips filtering out, add glue can drown the hanging basket, ad-added.

Suzhou immerse the filter of mechanical equipment co invention stir cooled one to immerse the bottle does not need to carry out such complex work, you only need to power on the line

Question 4:

Even for aluminum and other non-active parts, long-term use may also be brought into oil and water or other impurities, impurities in some could work on adhesive stability and possible defects.

Solution:

1 . At least once a month the impurities in the liquid with a cloth filter, such as artificial filters available 300-400 , such as bag filters with 400 .

2 . About half of liquid precipitation at one time 48 hours and then the lower sediment released total 5-10implementation this method is the industry clear pot.

Inspection method:

About once a week with 8mm tubes with 2-3 cm glue in 90-93℃ hot waters, preferably in chemical reagents easy to store a constant temperature water bath test. If 10 minutes curing is qualified, if there is more than 10﹪ liquid you can add more than a small amount of surfactant, addition of0.2respectively, add the amount can not be too much, preferably in the factory under the guidance adds.